Slint Printer Demo for the Raspberry Pi Pico
============================================

This archive holds the Slint printer demo, built for the Raspberry Pi Pico.

What You Need
=============

- Raspberry Pi Pico
- A Waveshare Pico-ResTouch-LCD-2.8 display, with the Pico plugged into it
- A USB cable

Flash the Demo
==============

1. Hold the BOOTSEL button while you connect the board to your computer over USB.
   The board shows up as a USB drive named RPI-RP2.
2. Copy printerdemo-pico-st7789.uf2 onto that drive.
   The board restarts and runs the demo.

To flash from the command line instead, put the board in BOOTSEL mode and run picotool:

    picotool load -x printerdemo-pico-st7789.uf2

Build It Yourself
=================

The demo's source is at https://github.com/slint-ui/slint/tree/master/demos/printerdemo_mcu
The build steps are at https://github.com/slint-ui/slint/tree/master/examples/mcu-board-support
