Slint Printer Demo for the Waveshare RP2350 Touch LCD 2.8″
==========================================================

This archive holds the Slint printer demo, built for the Waveshare RP2350 Touch LCD 2.8″.

What You Need
=============

- Waveshare RP2350 Touch LCD 2.8″
- A USB cable

Flash the Demo
==============

1. Hold the BOOTSEL button while you connect the board to your computer over USB.
   The board shows up as a USB drive named RP2350.
2. Copy printerdemo-pico2-touch-lcd-2-8.uf2 onto that drive.
   The board restarts and runs the demo.

To flash from the command line instead, put the board in BOOTSEL mode and run picotool:

    picotool load -x printerdemo-pico2-touch-lcd-2-8.uf2

Build It Yourself
=================

The demo's source is at https://github.com/slint-ui/slint/tree/master/demos/printerdemo_mcu
The build steps are at https://github.com/slint-ui/slint/tree/master/examples/mcu-board-support
